Skip to main content

Small components

note

Take your time and make sure the 1k trim pot is perfectly flat against the PCB before soldering all of its pins.

Next we'll do the remaining small, passive components.

  1. There are two small ceramic capacitors:
    1. The one marked 103 is for .01uF (also known as 10nF). It goes to C101. .01uF to C101
    2. The other's marked 104, for .1uF, and goes to C102. .1uF to C102
  2. The last cap is an electrolytic 10uF capacitor at C103.
    • Match the capacitor's white stripe to the white part of the footprint. 10uF to C103
  3. The remaining resistor is 1k ohms, colored Brown Black Red.
    • Solder to R102. 1k ohms to R102
  4. The small, blue 1k trim potentiometer goes to RV103. It's marked 102. Make sure it's flat against the PCB.
    • 1k trim pot to 102
  5. Nothing to test here, but check all solder joints and trim leads before moving on. We're almost done!